Ken McLauchlan IRE Interview - TRANSCRIPT

Editor's note: The following is the transcript of an live interview with Ken McLauchlan of Metal Forming. You can read the transcript below or watch the video.

Ken McLauchlan: Hi, it's Ken MCL with Metal Forming. We're excited to have you at the booth to premier our board and Batten profile in the Quadro. Really excited all the design and development that went into this. Our customers are excited. It's the first time it's been out at any of the shows. This is the profile we have about a three inch drop in the legs. It runs out of any 10 station machine for anybody that owns a Quadro. We can put this back in your machine for you. Standard Quadro fix with the performance pack on the other end, that takes up the line speed up to 65 feet per minute. Material can be ran outta coil or flats. Stock fed through rolls through the s slitting stations, through the other stations to the end of the panel machine, and then power fed outta the other end of the machine down to here.